Calgary Jeep Association

« previous next »
Pages: [1]   Go Down

Author Topic: Axle shaft runout  (Read 1095 times)

0 Members and 1 Guest are viewing this topic.

Offline dac

  • That CB Yapper
  • Posts: 516
Axle shaft runout
« on: October 17, 2008, 05:34:15 PM »
Does anyone know what the acceptable axleshaft and flange run out on a D44 rear is?
Logged
This is not 'Nam, this is wheeling.  There are rules.

Offline Bnine

  • Talks waaay too much!
  • Posts: 2572
  • Sticky Fingers
Re: Axle shaft runout
« Reply #1 on: October 20, 2008, 12:25:13 PM »
Should be no more then 30-50 thou. If you can visibly see it as obvious run out, there may be an issue.

Check both sides to confirm if one is out by a considerable amount.
Logged
My Mechanic Calgary
Mobile Auto Care
403-483-1083
[email protected]

Offline dac

  • That CB Yapper
  • Posts: 516
Re: Axle shaft runout
« Reply #2 on: October 20, 2008, 05:48:25 PM »
I checked the passenger side flange with dial calipers, the runout is maybe 3 thou.  The drivers side is is closer to 25 thou.  I can't see the driver side move but the bearing race on that side has a couple of scores on it.
Logged
This is not 'Nam, this is wheeling.  There are rules.
Pages: [1]   Go Up
« previous next »