Calgary Jeep Association

Author Topic: GEARS?  (Read 4226 times)

0 Members and 2 Guests are viewing this topic.

Offline adamnigh

  • Budget Lift
  • Posts: 107
GEARS?
« on: June 17, 2009, 10:57:39 AM »
okay guys, im ordering my new axles here soon, and i have the choice of gears obviosuly. So im running 36x12.5x15 TSL/SX'S, so what do you figure i should use for gears. i was thinking 4.56:1 but maybe 4.88:1. Is anyone runnin those size tires with either of those gears? If so, what do you think? Thanks for your help!
-Adam Nigh

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: GEARS?
« Reply #1 on: June 17, 2009, 11:10:45 AM »
okay guys, im ordering my new axles here soon, and i have the choice of gears obviosuly. So im running 36x12.5x15 TSL/SX'S, so what do you figure i should use for gears. i was thinking 4.56:1 but maybe 4.88:1. Is anyone runnin those size tires with either of those gears? If so, what do you think? Thanks for your help!
-Adam Nigh

The lower the better. 4:88. I am runing 4:88 with 33" tires.
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline adamnigh

  • Budget Lift
  • Posts: 107
Re: GEARS?
« Reply #2 on: June 17, 2009, 11:25:00 AM »
hows that driving on the highway? and how is your gas mileage??
thanks
-Adam

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: GEARS?
« Reply #3 on: June 17, 2009, 11:32:33 AM »
hows that driving on the highway? and how is your gas mileage??
thanks
-Adam

It runs about 2700 RPM at 100KM 5th gear not great for milage but it pulls up hills realy well. Your 36" tires would run that gearing well.  It's not likley any jeep is going for a high top end.  ;) 
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline adamnigh

  • Budget Lift
  • Posts: 107
Re: GEARS?
« Reply #4 on: June 17, 2009, 11:33:48 AM »
hahah very true. im sure anything is better than the mileage im getting now, 36's and 3.07's dont go well together

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: GEARS?
« Reply #5 on: June 17, 2009, 11:41:57 AM »
hahah very true. im sure anything is better than the mileage im getting now, 36's and 3.07's dont go well together

Crap I hated 3:07 and 33", yours must be a beast to drive. Ever get out of 2nd gear? 3rd must be a rare treat.  ;D
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline fug

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2345
  • Airdrie Pick n Pull
Re: GEARS?
« Reply #6 on: June 17, 2009, 11:42:27 AM »
another vote for 4.88's with 36's.  I've got 4.88's and have run both 35's and 37's... I can use 5th on the highway and my mileage is double digits again.
Fug
TJ Rubicon

Offline adamnigh

  • Budget Lift
  • Posts: 107
Re: GEARS?
« Reply #7 on: June 17, 2009, 11:47:22 AM »
every now and then i can throw it in fourth down a nice steep hill behind a semi with the wind pushing me hahah! alright, two people proven to be smarter than me have voted 4.88, my mind might be changing. im getting 300 clicks to a tank right now. what do you get FUG?

Offline fug

  • CJA Executive
  • Talks waaay too much!
  • Posts: 2345
  • Airdrie Pick n Pull
Re: GEARS?
« Reply #8 on: June 17, 2009, 11:55:56 AM »
Well over the past year I haven't even used a full tank.... HAHAHAHAHAHAHA

When it is actually on the road I seem to recall the gas light coming on around 350Km or so.
Fug
TJ Rubicon

Offline JackstandJohnny

  • Talks waaay too much!
  • Posts: 4727
  • where Jeeps go to die
Re: GEARS?
« Reply #9 on: June 17, 2009, 12:07:11 PM »
i run iroks and 4.56s. its adequate at BEST........................ go 4.88s; if i ever swap a D44 into it i'd run 5.13s......
~ rescue green JKUR on 35s.  typical rubicon build

Offline Spinalguy

  • Talks waaay too much!
  • Posts: 2759
    • http://www.spinalguy.com
Re: GEARS?
« Reply #10 on: June 17, 2009, 12:33:08 PM »
i ran 5.13's with 37's. my vote is 5.13.
sent from my old school rotary dial phone.

Offline adamnigh

  • Budget Lift
  • Posts: 107
Re: GEARS?
« Reply #11 on: June 17, 2009, 12:41:10 PM »
i think 5.13 might be a bit much for me. im thinking 4.88's will be my choice. i dont wanna go too low, this is still my daily driver lol

Offline The Machinist

  • CJA Members
  • That CB Yapper
  • Posts: 741
  • I’m with stupid!
Re: GEARS?
« Reply #12 on: June 17, 2009, 12:45:13 PM »
Out of curiosity, how much are you paying for those axles?  What kind of lockers?  Chromoly axle shafts?
I just can’t resist a good mud hole!  🤦

Offline adamnigh

  • Budget Lift
  • Posts: 107
Re: GEARS?
« Reply #13 on: June 17, 2009, 12:47:41 PM »
he quoted me at about 5 and a half grand, for two complete 44's, with any gear choice, the rear has a detroit, and the front has a detroit true trac, and yes chromoly shafts on both, with solid diff covers. and said if i pick them up and order them both at the same time hed work something out. how come?

Offline The Machinist

  • CJA Members
  • That CB Yapper
  • Posts: 741
  • I’m with stupid!
Re: GEARS?
« Reply #14 on: June 17, 2009, 12:50:27 PM »
Oh, I could use a set my self one of these days.
I just can’t resist a good mud hole!  🤦