Calgary Jeep Association

Author Topic: carpets  (Read 1123 times)

0 Members and 3 Guests are viewing this topic.

Offline lizard230

  • Budget Lift
  • Posts: 201
carpets
« on: May 07, 2010, 12:48:28 PM »
carpets are starting to stink and rot anyone got any suggestions
2000 TJ

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: carpets
« Reply #1 on: May 07, 2010, 12:51:55 PM »
carpets are starting to stink and rot anyone got any suggestions

I took them out and used good quality truckbed liner. Big job but now I can pull the drain plugs and wash it all out.  

If you want to keep them take them out and give them and the inside of the jeep a good wash. Let them dry fully before putting them back.
« Last Edit: May 07, 2010, 01:00:05 PM by 01sahara »
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline Evil-Jeep

  • UberWheeler
  • Posts: 319
Re: carpets
« Reply #2 on: May 07, 2010, 12:59:22 PM »
buy mine....... have had them stored in the basement since I brought the Jeep home
“I contend that we are both atheists. I just believe in one fewer god than you do. When you understand why you dismiss all the other possible gods, you will understand why I dismiss yours.”

Offline lizard230

  • Budget Lift
  • Posts: 201
Re: carpets
« Reply #3 on: May 07, 2010, 02:54:55 PM »
I took them out and used good quality truckbed liner. Big job but now I can pull the drain plugs and wash it all out.  

If you want to keep them take them out and give them and the inside of the jeep a good wash. Let them dry fully before putting them back.

how much was did it cost to get done or did u do it your self
2000 TJ

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: carpets
« Reply #4 on: May 07, 2010, 03:07:39 PM »
how much was did it cost to get done or did u do it your self

Did it my self. Takes a day or so to prep the surface for a good job. Material can run from $50-$200 depends on the quality of bedliner. 
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline lizard230

  • Budget Lift
  • Posts: 201
Re: carpets
« Reply #5 on: May 07, 2010, 03:22:00 PM »
Did it my self. Takes a day or so to prep the surface for a good job. Material can run from $50-$200 depends on the quality of bedliner. 

was it hard to do any special tool needed
2000 TJ

Offline RckyMtnTJ

  • UberWheeler
  • Posts: 393
    • http://www3.telus.net/lck
Re: carpets
« Reply #6 on: May 07, 2010, 03:40:26 PM »
Remove all interior, scuff all surfaces and remove shine.  I used scotch pads, sandpaper and a wire brush.  Clean really good with xylene, let dry and then either roll in, brush in, or spray in.  I brushed mine in and got pretty good results with Durabak.  If I had it to do over again, I definitely will/would spray it in for more consistent results.
98 TJ 4" lift + goodies

Offline 01sahara

  • Talks waaay too much!
  • Posts: 2892
Re: carpets
« Reply #7 on: May 07, 2010, 04:17:16 PM »
Remove all interior, scuff all surfaces and remove shine.  I used scotch pads, sandpaper and a wire brush.  Clean really good with xylene, let dry and then either roll in, brush in, or spray in.  I brushed mine in and got pretty good results with Durabak.  If I had it to do over again, I definitely will/would spray it in for more consistent results.


I used a product called Raptor. it is one of the higher $ spray on finishes. Prep the surface really well so you know it will stick. If you google Raptor beadliner and jeep there were a few good posts on the us Jeep sites with pics of others doing this to the interior.
Super Winch, 33" MT, 2 1/2" lift , CB, Flat Fender
http://melaman2.com/cartoons/singles/george-jungle.html

Offline lizard230

  • Budget Lift
  • Posts: 201
Re: carpets
« Reply #8 on: May 07, 2010, 06:58:33 PM »
ok so the carpets are out and i have ALOT of rust on the floor underneath my gas peddle on both drivers and passenger floors what are some options before i spray it
2000 TJ

Offline FiEND

  • Talks waaay too much!
  • Posts: 3775
  • Wrecking Ball
Re: carpets
« Reply #9 on: May 07, 2010, 09:36:45 PM »
drill and wire wheel.  wax on wax off. 
1Wide2High
ILV2FRT
'97 TJ [sold]
'17 JK Rubicon